Showing 2 results for Slitting Method
Umarfarooq Maktedar Abdulkhadar, Patil Somalinganagouda Shivakumargouda, Gonal Basavaraja Veeresh Kumar, Krishnaraja Govinda Kodancha,
Volume 18, Issue 3 (9-2021)
Abstract
Residual stress measurement is of utmost importance for the safety and reliability of engineering components and has been an active area of scientific research. Relaxation techniques such as hole drilling, slitting and ring core method are widely applied semi destructive techniques for residual stress measurements in polymer composites. This article reviews the recent literature on the measurement of residual stress in polymer composite by employing the above-mentioned relaxation techniques. This article summarizes the categories of residual stresses, causes of formation, techniques of measurements and also briefly outlines the chronological developments of the Hole drilling and slitting method. The article also provides a comparative summary of these relaxation methods.
Umarfarooq Maktedar Abdulkhadar, Patil Somalingana Shivakumar Gouda, Anil Shirahatti, Gonal Basavaraja Veeresh Kumar, Nagaraj Ramalingyya Banapurmath,
Volume 18, Issue 4 (12-2021)
Abstract
The energy release rate for delamination in a laminated composite is supposed to be the material property being considered as independent of non-material property variables. However, Mode I fracture toughness(GI) is found to vary with lamina arrangement, geometrical dimensions, and process-induced stresses. In this investigation, the influence of lamina stacking arrangement on process-induced stresses and their effects on GI of laminated composites are studied. Unidirectional (UD) ([0]16) and cross-ply ([902/06]s, [904/04]s and [906/02]s) Glass/ epoxy (GE) composites with the delamination plane at 0◦//0◦ were prepared by manual layup method and post-cured at 120 °C for 4 hours. GI of composite laminates were experimentally determined using a double cantilever beam(DCB) specimen as per ASTM D 5528. The slitting method was applied to determine the Process-induced stresses in GE laminates. The stacking sequence of laminas was found to have a noticeable effect on the state of residual stresses and GI of GE laminates. Residual stresses do not have much influence on the GI for delamination initiation, whereas GI for the crack propagation was found to increase with a gradual increase in compressive residual stresses in GE laminates.
